Tradim | halogen transformer | IP 20 | 35 - 105W

The Tradim ET35105R is a round electronic transformer especially suitable for low voltage (12V) halogen lamps. The round transformer is equipped with: a Soft Start (which promotes the service life of the lamps) Thermal protected Short circuit protected Overload protected Also, the round halogen transformer is dimmable with the most common dimmers. Light sources The Tradim ET35105R halogen transformer is suitable for the following lamps: Halogen lamps 12V with a total power between 35-105 W Maximum power This Tradim ET35105R halogen transformer is suitable for 35-105 W/VA. Never load the transformer more than 80% of the maximum power! What is an electronic halogen transformer? Electronic halogen transformers convert the mains voltage of 220 Volts to the safe 12 Volts low voltage. This type of transformer is therefore intended exclusively for halogen lamps that operate at this low voltage. Because of this lower voltage, these lamps can be used in, for example, the so-called "wet areas" (shower, bath, is also called zone 1) of bathrooms or used for ceiling spotlights. In these cases, the transformer is concealed above the ceiling. The size and power of the halogen transformer depends on the wattage and number of halogen lamps that can be connected. Therefore, there are different shapes and models of transformers. CAUTION: not suitable for dimmable 12V LED lamps Halogen transformers are NOT suitable for dimmable 12V LED lamps. The lamps will flicker, are poorly dimmable and will break down quickly. LED bulbs require much less power than halogen bulbs. If you switch to energy-efficient 12V dimmable LED lamps, it is very wise and also necessary to replace the transformer with a so-called dimmable LED driver. These are suitable for dimming LED lamps.